SPECIAL TOOLS


Tool
Number
Name
Use



    MB992080
    a: MB992081
    b: MB992082


    Belt tension meter set
    a: Belt tension meter
    b: Microphone assembly

Drive belt tension check



  1. MB992744
  2. MB992745
  3. MB992746
  4. MB992747
  5. MB992748


  1. Vehicle communication interface-Lite (V.C.I.-Lite)
  2. V.C.I.-Lite main harness A (for vehicles with CAN communication)
  3. V.C.I.-Lite main harness B (for vehicles without CAN communication)
  4. V.C.I.-Lite USB cable short
  5. V.C.I.-Lite USB cable long


  • Checking the ignition timing
  • Checking the idle speed



MB991955

    a: MB991824
    b: MB991827
    c: MB991910
    d: MB991911
    e: MB991825
    f: MB991826
M.U.T.-III sub assembly

    a: Vehicle communication interface (V. C. I.)
    b: M.U.T.-III USB cable
    c: M.U.T.-III main harness A (Vehicles with CAN communication system)
    d: M.U.T.-III main harness B (Vehicles without CAN communication system)
    e: M.U.T.-III adapter harness
    f: M.U.T.-III trigger harness
caution For vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly.

  • Checking the ignition timing
  • Checking the idle speed



MB992854
Magnet base plate
Intake side valve clearance check and adjustment


MD998913
Dial gauge extension
Intake side valve clearance check and adjustment


MB990767
Front hub and flange yoke holder
Holding the crankshaft pulley


MD998719
Pin


MD998772
Valve spring compressor
Valve spring compression


MB992090
Retainer holder attachment


MB992089
Retainer holder C


MB992085
Valve stem seal pliers
Valve stem seal removal


MB992677
Valve stem seal installer adjustable
Valve stem seal press-fitting


MD998727
Oil pan FIPG cutter
Engine oil pan removal


MB991883
Flywheel stopper
Supporting the flywheel <M/T> or drive plate <CVT>


MD998718
Crankshaft rear oil seal installer
Press-fitting the crankshaft rear oil seal


MB991448
Bush remover and installer base
Press-fitting the crankshaft front oil seal


MB991928

    a: MB991929
    b: MB991930
    c: MB991931
    d: MB991932
    e: MB991933
    f: MB991934
Engine hanger

    a: Joint (50) × 2
    b: Joint (90) × 2
    c: Joint (140) × 2
    d: Foot (standard) × 4
    e: Foot (short) × 2
    f: Chain and hook assembly
Supporting the engine assembly

  • For the engine hanger balancer (MB991454), use the chain only.
note Engine hanger balancer (MB991454) is a part of the engine hanger assembly (MB991453).


MB991895
Engine hanger


MB992906
Engine hanger attachment


MB991527
Hanger


MB991454
Engine hanger balancer


MB992853
Engine hanger plate


MB991956
Engine hanger plate