|
When removing the crankshaft pulley, slightly loosen the water pump pulley mounting bolts
before removal of the drive belt.
|
|
1.Secure special tool engine hanger (MB991928 or MB991895) for holding the engine assembly
(Refer to GROUP 22A -Transmission Assembly ) <M/T> or (Refer
to GROUP 23A -Transmission Assembly ) <CVT>.
|
|
2.Install special tool engine hanger plate (MB991956) to the motor bracket mounting of the
cylinder head.
|
|
3.Set the following special tools to special tool MB991956 and the engine hanger to hold
the engine assembly.
- Hanger (MB991527)
- Chain of engine hanger balancer (MB991454)
4.Adjust the special tool not to allow the weight of the engine and transmission assembly
to rest on the engine mounting bracket. Then remove the engine mounting bracket.
|
|
For the removal procedure, refer to GROUP 11D - Oil Pan and Timing Chain Case .
|
|
For the installation procedure, refer to GROUP 11D - Oil Pan and Timing Chain
Case .
|
|
Use the special tool as during removal to install the engine mounting bracket.
|
|
Temporarily tighten the water pump pulley mounting bolts. Then, tighten them to the specified
torque after the installation of drive belt.
|
|
Tightening torque: 9.0 ± 1.0 N·m
|
|
For the installation procedure, refer to GROUP 11D - Oil Pan and Timing Chain
Case .
|