REMOVAL AND INSTALLATION



caution
  • When removing or installing the manifold absolute pressure sensor, be careful not to apply impact to the sensor.
  • Do not reuse the manifold absolute pressure sensor that has been dropped.




Removal steps


1.
Vacuum pipe and hose


2.
Purge hose


3.
Chamber


4.
Throttle body stay


5.
Throttle body

>>B<<
6.
Throttle body gasket

>>A<<
7.
Purge control solenoid valve

>>A<<
8.
O-ring

>>A<<
9.
Manifold absolute pressure (MAP) sensor

>>A<<
10.
O-ring

INSTALLATION SERVICE POINTS



>>A<< O-RING/MANIFOLD ABSOLUTE PRESSURE SENSOR/PURGE CONTROL SOLENOID VALVE INSTALLATION


1.Apply a small amount of new engine oil to the O-ring.
2.Install the manifold absolute pressure sensor and the purge control solenoid valve to the inlet manifold with care not to damage the O-ring.
3.
caution Do not over-tighten. If the mounting screw is over-tightened, the inlet manifold can be damaged.
Tighten the mounting screws to the specified torque.
Tightening torque: 4.0 ± 1.0 N·m

>>B<< THROTTLE BODY GASKET INSTALLATION



Fit the throttle body gasket in the inlet manifold groove securely with neither twisting nor damage given.