|
Assemble the thermostat housing and water pipe, and temporarily tighten them to the cylinder
head and water pump. Then tighten them to the specified torque of 24 ± 3 N·m.
|
|
Install the thermostat with the jiggle-valve facing almost straight upwards.
|
|
1.Apply an appropriate and minimum amount of sealant to the coolant temperature sensor,
taking care not to allow sealant to squeeze out. Specified sealant:
ThreeBond 1324N, Loctite 262 or equivalent
2.Tighten the coolant temperature sensor to the cylinder block to the specified torque
of 30 ± 9 N·m.
|