ENGINE OIL REPLACEMENT


<4B1, 4J1>
1.Start the engine and allow it to warm up until the temperature of the coolant reaches 80 °C to 90 °C.
2.
warning Use care as engine oil could be hot.
Remove the engine oil filler cap.
3.Remove the engine oil pan drain plug to drain engine oil.
4.Install a new engine oil pan drain plug gasket and then tighten the engine oil pan drain plug to the specified torque.
Tightening torque: 39 ± 5 N·m

5.Refill with specified quantity of engine oil.
Specified engine oil:

  • ACEA classification: A1/B1, A3/B3, A3/B4 or A5/B5
  • ILSAC classification: ILSAC certificated oil
  • API classification: SM or higher
Total quantity (Includes volume inside engine oil filter and engine oil cooler):

  • <4B11, 4J1>

    • <Vehicles without engine oil cooler> 4.3 L
    • <Vehicles with engine oil cooler> 4.4 L
  • <4B12> 4.6 L
note SAE 0W-20*, 0W-30, 5W-30, and 5W-40 engine oils can only be used if they meet ACEA A3/B3, A3/B4 or A5/B5 and API SM or higher specifications.
note *: Vehicles to comply with the Euro 4 regulation
6.Install the engine oil filler cap.
7.Let the engine run for a few minutes.
8.Stop the engine, and then check the engine oil level using the engine oil level gauge after a few minutes.

<4N1>
1.Start the engine and allow it to warm up until the temperature of the engine coolant reaches 80°C to 90°C.
2.
warning Use care as engine oil could be hot.
Remove the engine oil filler cap.
3.Remove the engine room under cover front (Refer to GROUP 51 - Under Cover ).
4.Remove the engine oil pan drain plug to drain engine oil.
5.Install a new engine oil pan drain plug gasket and then tighten the engine oil pan drain plug to the specified torque.
Tightening torque: 39 ± 5 N·m

6.Refill with specified quantity of engine oil.
Specified Engine Oil

  • ACEA classification: "For service C1, C2, C3 or C4"
  • JASO classification: "For service DL-1"
Total quantity (Includes volume inside engine oil filter and engine oil cooler):

  • <Vehicles without engine oil cooler> 5.8 L
  • <Vehicles with engine oil cooler> 5.9 L
7.Install the engine oil filler cap.
8.Let the engine run for a few minutes.
9.Stop the engine, and then check the engine oil level using the engine oil level gauge after a few minutes.
10.Install the engine room under cover front (Refer to GROUP 51 - Under Cover ).