).| 1.Remove the engine oil pan drain plug to drain engine oil (Refer to ). |
) |
2.Use special tool oil filter wrench (MB991396) or commercially-available tool to remove
the engine oil filter. 3.Clean the engine oil filter installing surface on the cylinder block side. |
) |
4.Apply a small amount of engine oil to the new engine oil filter O-ring. 5.Tighten the engine oil filter until the O-ring contacts with the installation surface. |
|
6.In the same manner as removal, use special tool oil filter wrench (MB991396) or commercially-available
tool to tighten the engine oil filter to the specified torque. Tightening torque: Approximately 1 turn (14 ± 2 N·m) 7.Install the engine oil pan drain plug and refill the engine oil (Refer to ).8.Rev the engine a few times, and check to be sure that no engine oil leaks from the installation section of the engine oil filter. 9.Install the engine room under cover front (Refer to GROUP 51 - Under Cover ) <4N1>. |