REMOVAL AND INSTALLATION <4J1-CVT>



Pre-removal Operation
  • Engine Room Under Cover Front A, B Removal (Refer to GROUP 51 - Under Cover ).
  • Engine Coolant Draining (Refer to GROUP 14 - On-vehicle Service, Engine Coolant Replacement ).
  • Engine Oil Filter Removal (Refer to ).

Post-installation Operation
  • Engine Oil Filter Installation (Refer to ).
  • Engine Coolant Refilling (Refer to GROUP 14 - On-vehicle Service, Engine Coolant Replacement ).
  • Engine Room Under Cover Front A, B Installation (Refer to GROUP 51 - Under Cover ).





Removal steps


1.
Water return hose connection


2.
Water feed hose connection

>>A<<
3.
Engine oil cooler bolt

>>A<<
4.
Engine oil cooler assembly

>>A<<
5.
Engine oil cooler gasket

INSTALLATION SERVICE POINT



>>A<< ENGINE OIL COOLER GASKET/ENGINE OIL COOLER ASSEMBLY/ENGINE OIL COOLER BOLT INSTALLATION


1.Apply a small amount of new engine oil to the engine oil cooler gasket, and install it to the engine oil cooler assembly.

2.Align the projection for positioning the engine oil cooler assembly with the position of ladder frame as shown in the figure, and install the engine oil cooler assembly.
3. Tighten the engine oil cooler bolt to the specified torque.
Tightening torque: 27 ± 2 N·m