)
and turn up the floor carpet.| When removing the fuel pipes and fuel hoses, follow the procedure below to release fuel
pressure in the line and prevent fuel from running out, because fuel pressure in the fuel line
is high. |
| 1.Remove the second seat assembly (Refer to GROUP 52A - Second Seat Assembly )
and turn up the floor carpet. |
) |
2.Remove the floor inspection lid (LH). |
) |
3.Disconnect the fuel tank pump and gauge assembly connector. 4.Crank the engine for at least two seconds. 5.If the engine does not start, turn the ignition switch to the "LOCK" (OFF) position. 6.If the engine is started, turn the ignition switch to the "LOCK" (OFF) position after the engine stopped. 7.Connect the fuel tank pump and gauge assembly connector. 8.Install the floor inspection lid (LH). 9.Return the floor carpet to the original condition and install the second seat assembly (Refer to GROUP 52A - Second Seat Assembly ). |