|
1.Disconnect the electronic-controlled throttle valve connector.
|
|
2.Remove the air intake hose from the throttle body.
|
|
3.Remove the throttle body assembly.
caution |
Do not spray the cleaning fluid directly to the throttle valve.
|
|
|
4.Spray the cleaning fluid on a clean cloth.
caution |
- Make sure it does not enter the sensor through
the shaft.
- Do not remove molybdenum. which is applied around the throttle valve of the throttle
body.
|
|
|
5.Wipe off the dirt around the throttle valve with the cloth sprayed with cleaning fluid. 6.Install the throttle body assembly. 7.Install the air intake hose. 8.Connect the electronic-controlled throttle valve connector.
|