|
- Item 170: Valve lift sensor
- Engine: Idle operation after warm-up
|
|
OK: 0.2 - 4.8 V (depends on engine operation condition)
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- Disconnect connector, and measure at harness side.
- Resistance between terminal engine-ECU VLSE line and body earth.
|
|
OK: Continuity (2 Ω or less)
|
|
Q.
Is the check result normal?
|
|
- Check earthing line for open circuit and damage.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|
|
- Item 170: valve lift sensor
- Engine: Idle operation after warm-up
|
|
OK: 0.2 - 4.8 V (depends on engine operation condition)
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- Item 170: Valve lift sensor
- Engine: Idle operation after warm-up
|
|
OK: 0.2 - 4.8 V (depends on engine operation condition)
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- After replacing the valve lift sensor, reconfirm whether the diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|