|
Q.
Is diagnosis code set?
|
|
Inspection chart for diagnosis code (Refer to ).
|
|
|
|
- Confirm the diagnosis code is set from CVT-ECU.
|
|
Q.
Is the diagnosis code set?
|
|
Perform troubleshooting of CVT System (Refer to GROUP 23A - Diagnosis Code Chart ).
|
|
|
|
- Injector check (Refer to ).
|
|
Q.
Is operating sound audible?
|
|
Check the injector system of the defective cylinder. Check code No. P0261: No. 1 injector circuit low input (Refer to ). Check code No. P0262: No. 1 injector circuit high input (Refer to ). Check code No. P0264: No. 2 injector circuit low input (Refer to ). Check code No. P0265: No. 2 injector circuit high input (Refer to ). Check code No. P0267: No. 3 injector circuit low input (Refer to ). Check code No. P0268: No. 3 injector circuit high input (Refer to ). Check code No. P0270: No. 4 injector circuit low input (Refer to ). Check code No. P0271: No. 4 injector circuit high input (Refer to ).
|
|
|
|
- Data list reference table (Refer to ).
- Item 5: Intake air temperature sensor
- Item 6: Engine coolant temperature sensor
- Item 11: Accelerator pedal position sensor (main)
- Item 12: Accelerator pedal position sensor (sub)
- Item 13: Throttle position sensor (main)
- Item 15: Throttle position sensor (sub)
- Item BB: Barometric pressure sensor
|
|
Q.
Are the check results normal?
|
|
Perform the diagnosis code classified check procedure for the sensor that has shown an abnormal data value. Inspection chart for diagnosis code (Refer to ).
|
|
|
|
- Check purge control solenoid valve itself (Refer to GROUP 17- Emission Control - Evaporative Emission Control System - Purge Control Solenoid Valve Check ).
|
|
Q.
Is the check result normal?
|
|
Replace the purge control solenoid valve.
|
|
|
|
- Data list reference table (Refer to ).
- Item AC: Oxygen sensor (front)
- Item AD: Oxygen sensor (rear)
|
|
Q.
Are the check results normal?
|
|
Perform the diagnosis code classified check procedure for the sensor that has shown an abnormal data value. Inspection chart for diagnosis code (Refer to ).
|
|
|
|
- Remove the spark plug and install it to the ignition coil.
- Connect the ignition coil connector.
- Disconnect all injector connectors.
- At the engine start, check each spark plug produces a spark.
|
|
Q.
Is the check result normal?
|
|
Check Inspection Procedure - ignition circuit system (Refer to ).
|
|
|
|
Q.
Is the check result normal?
|
|
Throttle body (throttle valve area) cleaning (Refer to ).
|
|
|
|
- Check the compression pressure (Refer to GROUP 11A - On-vehicle Service - Compression Pressure Check ).
|
|
Q.
Is the check result normal?
|
|
- Fuel pressure test (Refer to ).
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|