|
Q.
Is the diagnosis code set?
|
|
Inspection chart for diagnosis code (Refer to ).
|
|
|
|
- Confirm the diagnosis code is set from CVT-ECU.
|
|
Q.
Is the diagnosis code set?
|
|
Perform troubleshooting of CVT System (Refer to GROUP 23A - Troubleshooting - Diagnosis
Code Chart ).
|
|
|
|
- Check injector for operating sound (Refer to ).
|
|
Q.
Is operating sound audible?
|
|
Check the injector system of the defective cylinder. Check code No. P0261: No.
1 injector circuit low input (Refer to ). Check code No. P0262:
No. 1 injector circuit high input (Refer to ). Check code No.
P0264: No. 2 injector circuit low input (Refer to ). Check code
No. P0265: No. 2 injector circuit high input (Refer to ). Check
code No. P0267: No. 3 injector circuit low input (Refer to ).
Check code No. P0268: No. 3 injector circuit high input (Refer to ).
Check code No. P0270: No. 4 injector circuit low input (Refer to ). Check
code No. P0271: No. 4 injector circuit high input (Refer to ).
|
|
|
|
- Refer to Data List Reference Table .
- Item 5: Intake air temperature sensor
- Item 6: Engine coolant temperature sensor
- Item 11: Accelerator pedal position sensor (main)
- Item 12: Accelerator pedal position sensor (sub)
- Item 13: Throttle position sensor (main)
- Item 15: Throttle position sensor (sub)
- Item BB: Barometric pressure sensor
|
|
Q.
Are the check results normal?
|
|
Perform the diagnosis code classified check procedure for the sensor that has
shown an abnormal data value (Refer to Inspection Chart for Diagnosis Code ).
|
|
|
|
- Purge control solenoid valve connector check.
- Check purge control solenoid valve itself (Refer to GROUP 17 - Emission
Control <MPI> - Evaporative Emission Control System - Purge Control Solenoid
Valve Check ).
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or replace the purge control solenoid valve.
|
|
|
|
- Refer to Data List Reference Table .
- Item AC: Oxygen sensor (front)
- Item AD: Oxygen sensor (rear)
|
|
Q.
Are the check results normal?
|
|
Perform the diagnosis code classified check procedure for the sensor that has
shown an abnormal data value (Refer to Inspection Chart for Diagnosis Code ).
|
|
|
|
- Remove the spark plug and install it to the ignition coil.
- Connect the ignition coil connector.
- Disconnect all injector connectors.
- At the engine start, check each spark plug produces a spark.
|
|
Q.
Is the check result normal?
|
|
Check Inspection Procedure - ignition circuit system (Refer to ).
|
|
|
|
Q.
Is the check result normal?
|
|
Clean throttle body (throttle valve portion) (Refer to ).
|
|
|
|
- Check the compression pressure (Refer to GROUP 11C - On-vehicle
Service - Compression Pressure Check ).
|
|
Q.
Is the check result normal?
|
|
- Fuel pressure measurement (Refer to ).
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|