|
- Use M.U.T.-III to perform CAN bus line diagnosis.
|
|
Q.
Is the check result normal?
|
|
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting - CAN Bus Diagnostics Table ). After repairing the CAN bus line, go to Step 4.
|
|
|
|
- Confirm the diagnosis code is set from the KOS-ECU.
|
|
Q.
Is diagnosis code set?
|
|
Perform troubleshooting of KOS-ECU (Refer to GROUP 42B - Troubleshooting - Diagnosis Code Chart .
|
|
|
|
- Reconfirmation of diagnosis code.
|
|
Confirm again the diagnosis code is set from the engine-ECU.
|
|
- Erase the set diagnosis code.
- Ignition switch: LOCK (OFF) → ON
- Confirm whether the diagnosis code is set.
|
|
Q.
Is diagnosis code set?
|
|
After replacing engine-ECU, go to Step 4.
|
|
|
|
Intermittent malfunction in CAN bus line between engine-ECU and KOS-ECU (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- Reconfirmation of diagnosis code.
|
|
Confirm again the diagnosis code is set from the engine-ECU.
|
|
- Erase the set diagnosis code.
- Ignition switch: LOCK (OFF) → ON
- Confirm whether the diagnosis code is set.
|
|
Q.
Is diagnosis code set?
|