Code No. U0415: ASC-ECU CAN Data Abnormality



caution If diagnosis code U0415 is set from engine-ECU, surely perform CAN bus line diagnosis.
caution Replace ECU after certainly confirming that the communication circuits are normal.

TROUBLE JUDGMENT


Check Conditions
Judgement Criterion

COMMENTS ON TROUBLE SYMPTOM


Current malfunction
Past malfunction

FAIL-SAFE AND BACKUP FUNCTION




PROBABLE CAUSES




DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnosis



  • Use M.U.T.-III to perform CAN bus line diagnosis.

Q. Is the check result normal?

Go to Step 2.
Repair CAN bus line (Refer to GROUP 54C - Troubleshooting - CAN Bus Diagnosis Table ). After repairing CAN bus line, go to Step 6.

STEP 2. M.U.T.-III diagnosis code



  • Confirm the diagnosis code is set from the ASC-ECU.

Q. Is diagnosis code set?

Perform troubleshooting of the active stability control (ASC) system (Refer to GROUP 35C - Troubleshooting - Diagnosis Code Chart ).
Go to Step 3.

STEP 3. M.U.T.-III diagnosis code


Check that the other ECU performing CAN communication with ASC-ECU sets diagnosis code No. U0415 [Refer to GROUP 54C - CAN-related Diagnosis Code Table ].

Q. Is diagnosis code set?

Go to Step 4.
Go to Step 5.

STEP 4. M.U.T.-III diagnosis code



  • Reconfirmation of diagnosis code.
Confirm again the diagnosis code is set from the engine-ECU.

  1. Erase the set diagnosis code.
  2. Ignition switch: LOCK (OFF) → ON
  3. Confirm whether the diagnosis code is set.

Q. Is diagnosis code set?

After replacing ASC-ECU, go to Step 6.
Intermittent malfunction in CAN bus line between engine-ECU and ASC-ECU (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).

STEP 5. M.U.T.-III diagnosis code



  • Reconfirmation of diagnosis code.
Confirm again the diagnosis code is set from the engine-ECU.

  1. Erase the set diagnosis code.
  2. Ignition switch: LOCK (OFF) → ON
  3. Confirm whether the diagnosis code is set.

Q. Is diagnosis code set?

After replacing engine-ECU, go to Step 6.
Intermittent malfunction in CAN bus line between engine-ECU and ASC-ECU (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).

STEP 6. M.U.T.-III diagnosis code



  • Reconfirmation of diagnosis code.
Confirm again the diagnosis code is set from the engine-ECU.

  1. Erase the set diagnosis code.
  2. Ignition switch: LOCK (OFF) → ON
  3. Confirm whether the diagnosis code is set.

Q. Is diagnosis code set?

Go to Step 1.
Check end.