|
- Refer to Data List Reference Table .
- Item 9: Accelerator pedal position sensor (main)
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- Disconnect connector, and measure at harness side.
- Ignition switch: ON
- Voltage between terminal engine-ECU APS5 line and body earth.
|
|
Q.
Is the check result normal?
|
|
- Check power supply line for open/short circuit.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|
|
- Refer to Data List Reference Table .
- Item 9: Accelerator pedal position sensor (main)
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- Disconnect connector, and measure at harness side.
- Resistance between terminal engine-ECU APSE line and body earth.
|
|
OK: Continuity (2 Ω or less)
|
|
Q.
Is the check result normal?
|
|
- Check earthing line for damage.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|
|
- Use special tool test harness (MB991658) to connect connector, and measure
at pick-up harness.
- Ignition switch: ON
- Voltage between terminal engine-ECU APSM line and body earth.
|
|
Q.
Is the check result normal?
|
|
- Check output line for short circuit.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|
|
- Check power supply line for damage.
|
|
Q.
Is the check result normal?
|
|
Replace the accelerator pedal assembly.
|
|
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|
|
- Check output line for open circuit and damage.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the connector, or repair the damaged harness wire.
|
|
|