REMOVAL AND INSTALLATION


Pre-removal and Post-installation OperationAir Cleaner Body and Air Intake Pipe Removal and Installation (Refer to GROUP 15 - Air Cleaner ).




Removal steps


1.
 Fuel line protector


2.
 Fuel line heater connector

>>B<<
 3.
 Fuel line hose connection
<<A>>
4.
 Fuel filter bracket and fuel filter assembly


5.
 Fuel filter bracket


6.
 Fuel filter assembly


7.
 Exhaust pressure pipe assembly connection


8.
 Fuel filter bracket


9.
 Fuel line plug (drain plug)


10.
 Water level switch
<<B>>
 >>A<<
 11.
 Fuel filter


12.
 Fuel filter body

REMOVAL SERVICE POINT

<<A>> FUEL FILTER BRACKET AND FUEL FILTER ASSEMBLY REMOVAL

caution Remove the fuel filter bracket and fuel filter assembly taking care not to deform the fuel filter bracket.
Remove the fuel filter bracket and fuel filter assembly from the stud of the fuel filter bracket by raising it slightly.

<<B>> FUEL FILTER REMOVAL

Fix the fuel filter body to a vice, and then remove the fuel filter using an oil filter wrench.

INSTALLATION SERVICE POINTS

>>A<< FUEL FILTER INSTALLATION
1.Clean the mounting surface on the fuel filter body side.
2.Tighten the fuel filter to the specified torque from the point where the gasket contacts the mounting surface.
Tightening torque: Approximately 3/4 turn (17 ± 2 N·m)

>>B<< FUEL LINE HOSE INSTALLATION

If the pipe has a stepped part, connect securely up to the stepped part. If the pipe has no stepped part, insert so that the inserted portion 25 - 30 mm long.