|
1.Make mating marks on the radiator hose and the hose clip as shown to install them in the
original position.
|
|
2.Break off the tip of hose clip claw and spread out the hose clip, then disconnect the
radiator hose.
| note |
If there is a hose clip claw, the hose clip cannot spread to capacity because the claw
contacts the hose clip.
|
|
|
|
1.
| caution |
Never reuse the hose clip whose claw is broken off to prevent
the rusting.
|
Make mating mark on a new hose clip in the same position as the remove one.
|
|
2.Insert the radiator hose until the protrusion of the pipe.
3.Align the mating marks on the radiator hose and hose clip.
4.Remove the hose clip claw and shorten the hose clip, then install the radiator hose.
|
).)
)
)
)