|
1.Make mating marks on the radiator lower hose and the hose clip as shown to install them
in the original position.
|
|
2.Break off the tip of hose clip claw and spread out the hose clip, then disconnect the
radiator lower hose.
note |
If there is a hose clip claw, the hose clip cannot spread to capacity because the claw
contacts the hose clip.
|
|
|
Install the thermostat with care to avoid peeling or damage to the rubber ring. When installing
the thermostat, face the jiggle valve of the thermostat upward.
|
|
Fit the O-ring in the pipe groove, wet the O-ring circumference or the pipe mounting area
inner wall, and then insert the O-ring.
|
|
1.
caution |
Never reuse the hose clip whose claw is broken off to prevent
the rusting.
|
Make mating mark on a new hose clip in the same position as the remove one.
|
|
2.Insert the radiator lower hose until the protrusion of the radiator lower pipe. 3.Align the mating marks on the radiator lower hose and hose clip. 4.Remove the hose clip claw and shorten the hose clip, then install the radiator lower
hose.
|