|
Check the following points; replace the part if a problem
is found.
|
|
1.Check for damage or cracking of any part.
|
|
2.Using a straight edge and a feeler gauge, check for distortion of the cylinder head
installation surface.
<Cylinder head side>
Standard value : 0.70 mm Limit : 1.00 mm
<Turbocharger side>
Standard value : 0.50 mm Limit : 0.60 mm
|
|
1.Visually check the turbine wheel and the compressor wheel for cracking or other damage.
|
|
2.Check whether the turbine wheel and the compressor wheel can be easily turned by hand.
|
|
3.Check for oil leakage from the turbocharger assembly.
|
|
4.Check whether or not the turbocharger VG actuator remains open. If any problem is
found, replace the part after disassembly.
|