REMOVAL AND INSTALLATION

Pre-removal and Post-installation Operation

Engine Upper Cover Removal and Installation (Refer to GROUP 13D - Fuel Injector ).

			Removal steps
		·	Harness bracket assembly (Refer to GROUP 13D - Common Rail )
		1.	Glow plug harness
	>>A<<	2.	Glow plug

INSTALLATION SERVICE POINT

>>A<< GLOW PLUG INSTALLATION

caution

When removing or installing the glow plug, be careful not to let the glow plug end touch the cylinder head hole.
Do not reuse the glow plug that has been dropped.
Do not use power tools for glow plug installation otherwise the glow plug might be damaged.
Manually tighten the glow plug until it is seated. Then, tighten it to the specified torque.

Tightening torque: 18 ± 2 N·m