|
|
1.Turn the ignition switch to the "ON" position.
|
|
2.Push the cruise control ON/OFF switch of the cruise control switches, and check that the cruise control indicator lamp within the combination meter illuminates <standard meter>
or the cruise control display screen is displayed on the multi information display in the combination meter <high contrast meter>.
3.Push the cruise control ON/OFF switch again, and check that the cruise control indicator lamp within the combination meter <standard meter>
or the cruise control display screen goes out <high contrast meter>.
|
|
|
1.Turn the ignition switch to the "ON" position.
|
|
2.Push the speed limiter ON/OFF switch of the cruise control switches, and check that the speed limiter display screen is displayed on the multi information display in the combination meter.
3.Push the speed limiter ON/OFF switch again, and check that the speed limiter display screen goes out.
|
|
|
1.Turn the ignition switch to the "ON" position.
|
|
|
2.Push the cruise control ON/OFF switch (cruise control system: ON, cruise control indicator lamp: illuminated <standard meter>, cruise control display screen: display <high contrast meter>). Or Push the speed limiter ON/OFF switch (cruise control system: ON, speed limiter display screen: display).
|
|
|
3.Drive at the desired speed within the range of approximately 40 -
160 km/h.
|
|
4.Push the SET -
switch.
5.Check to be sure that when the SET -
switch is released the speed is the desired constant speed. The speed limiter will store a set vehicle speed, and then regulate the vehicle speed within that stored speed.
| note |
If the vehicle speed decreases to approximately 15 km/h below the set speed because of climbing a hill for example, it is normal for the cruise control to be cancelled. When the vehicle speed is decelerated to the low speed limit (approximately 40 km/h) or less, the constant speed driving will be cancelled even if the vehicle speed is not decelerated 15 km/h or more from the set speed.
|
| note |
On the high contrast meter, when SET -
switch is pressed, "SET" will be displayed on the multi information display in the combination meter.
|
|
|
|
1.Turn the ignition switch to the "ON" position.
|
|
|
2.Push the cruise control ON/OFF switch (cruise control system: ON, cruise control indicator lamp: illuminated <standard meter>, cruise control display screen: display <high contrast meter>). Or Push the speed limiter ON/OFF switch (cruise control system: ON, speed limiter display screen: display).
|
|
|
3.Set to the desired speed within the range of approximately 40 -
160 km/h.
|
|
4.Push the RES +
switch.
5.Check to be sure that acceleration continues while the RES +
switch is pushed, and that the speed at the time it was released becomes the constant driving speed. Every time the RES +
switch is pressed briefly, the speed limiter will store a vehicle speed. The speed limiter will regulate the vehicle speed within that last stored speed.
| note |
Acceleration can be continued even if the vehicle speed has passed the high speed limit (approximately 160 km/h). But the constant driving speed when the RES +
switch is released will be recorded as the high speed limit (approximately 160 km/h).
|
|
|
|
1.Turn the ignition switch to the "ON" position.
|
|
|
2.Push the cruise control ON/OFF switch (cruise control system: ON, cruise control indicator lamp: illuminated <standard meter>, cruise control display screen: display <high contrast meter>). Or Push the speed limiter ON/OFF switch (cruise control system: ON, speed limiter display screen: display).
|
|
|
3.Set to the desired speed within the range of approximately 40 -
160 km/h.
|
|
|
5.Check to be sure that deceleration continues while the SET -
switch is pushed, and that the speed at the time it was released becomes the constant driving speed. Every time the SET -
switch is pressed briefly, the speed limiter will store a vehicle speed. The speed limiter will regulate the vehicle speed within that last stored speed.
|
|
|
1.Turn the ignition switch to the "ON" position.
|
|
|
2.Push the cruise control ON/OFF switch (cruise control system: ON, cruise control indicator lamp: illuminated <standard meter>, cruise control display screen: display <high contrast meter>). Or Push the speed limiter ON/OFF switch (cruise control system: ON, speed limiter display screen: display).
|
|
|
3.Set to the desired speed within the range of approximately 40 -
160 km/h.
|
|
4.When any of the following operations are performed while at constant speed during cruise control, check if normal driving is resumed and deceleration occurs. Check that the speed limiter is deactivated by pressing the CANCEL switch.
| note |
The accelerator pedal must NOT be depressed.
|
(1)
The CANCEL switch is pushed.
(2)
The brake pedal is depressed.
5.At a vehicle speed of the low speed limit (approximately 40 km/h) or higher, check if when the RES +
switch is pushed, the vehicle speed returns to the speed before cruise control driving was cancelled, and constant speed driving occurs.
6.When the cruise control ON/OFF switch is pushed again (cruise control system: OFF) while driving at constant speed, check if normal driving is resumed and deceleration occurs.
| note |
The accelerator pedal must NOT be depressed.
|
|
)
)
)
)
)
)
)
)
)