CRUISE CONTROL SWITCH CHECK


1.Remove the cruise control switch (Refer to ).

2.Measure the resistance between terminal No.1 and terminal No.2 when each of the ACC distance switches is pressed. Measure the resistance between terminal No.3 and terminal No.4 when each of the speed limiter ON/OFF, cruise control ON/OFF, CANCEL, SET - and RES + switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
Terminal connector of tester
Switch position
Specified condition
1 - 2
ACC distance switch is pressed
Continuity (less than 2Ω)
3 - 4
All switches are released.
Open circuit
Speed limiter ON/OFF switch is pressed
Continuity (less than 2Ω)
Cruise control ON/OFF switch is pressed
176 - 179.5Ω
CANCEL switch is pressed
460 - 469.5Ω
SET - switch is pressed
1030.5 - 1051 Ω
RES + switch is pressed
2725 - 2836.5 Ω
3.Check that illumination of the cruise control switch turns on when the battery positive terminal is connected to cruise control switch connector terminal No.5, and the battery negative terminal is connected to cruise control switch connector terminal No.6.