|
Using M.U.T.-III, perform CAN bus diagnosis (Refer to GROUP 54C -
Explanation
About The M.U.T-III Can Bus Diagnostics ).
|
|
Q.
Is the check result satisfactory?
|
|
Repair the CAN bus lines (Refer to GROUP 54C -
Troubleshooting, Can Bus
Diagnostic Table ). Then go to Step 6.
|
|
|
|
Using M.U.T.-III, perform diesel fuel system diagnosis code (Refer to GROUP 13D -
Troubleshooting,
Diagnosis Function ).
|
|
Q.
Is diagnosis code No.U0141 set?
|
|
Repair the diesel fuel system (Refer to GROUP 13D -
Troubleshooting,
Diagnosis Code Procedures, Code No.U0141: ETACS-ECU Time-out ).
Then go to Step 6.
|
|
|
|
Using M.U.T.-III, perform ETACS system diagnosis code (Refer to GROUP 54A -
ETACS,
Troubleshooting, Diagnosis Function ).
|
|
Q.
Is diagnosis code No.U0155 set?
|
|
Repair the ETACS system (Refer to GROUP 54A -
Troubleshooting, Diagnosis
Code Procedures, Code No.U0155: Combination Meter-ECU CAN Communication Timeout ).
Then go to Step 6.
|
|
|
|
Using M.U.T.-III, check the combination meter system actuator test (Refer to GROUP 54A -
Combination
Meter, Troubleshooting, Actuator Test Table ).
|
|
Q.
Is the check result normal?
|
|
Repair the combination meter system (Refer to GROUP 54A -
Combination
Meter, Troubleshooting, Symptom Procedures, Inspection Procedure 4 ).
Then go to Step 6.
|
|
|
|
Q.
When the cruise control ON/OFF switch is turned ON, is the cruise control
indicator lamp illuminated?
|
|
It can be assumed that this malfunction is intermittent (Refer to GROUP 00 -
How
to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunction ).
|
|
|
|
Replace the engine-ECU (Refer to GROUP 13D -
Engine-ECU ).
Then go to Step 6.
|
|
|
|
Q.
When the cruise control ON/OFF switch is turned ON, is the cruise control
indicator lamp illuminated?
|
|
The procedure is complete.
|
|
|