Code No.C1753: ACC/FCM Radar Blockage Detected
caution |
- If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
- Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
|
OPERATION
The ACC/FCM-ECU monitors whether the radar is contaminated or its beam is blocked by foreign material.
DIAGNOSIS CODE SET CONDITION
This diagnosis code is set when the abnormality below is detected:
- cruise control switch "ON" or FCM switch "ON"
- The ACC/FCM-ECU' radar detection performance is deteriorated or its detection is interfered
PROBABLE CAUSES
- The radar is contaminated by dirt or foreign material, etc.
- Improperly installed ACC/FCM-ECU
- Malfunction of ACC/FCM-ECU
|
STEP 1. Check the radar for dirt or foreign material.
|
|
(1)Wipe off the dirt or foreign material from the ACC/FCM-ECU's radar.
|
|
(2)Erase the diagnosis code.
|
|
(3)Drive the vehicle for approx. five minutes.
|
|
(4)Check if the diagnosis code is set.
|
|
Q.
Is diagnosis code No.C1753 set?
|
|
Go to Step 2
|
|
|
|
This diagnosis is complete(Protection is deactivated)
|
|
|
|
STEP 2. Check whether the ACCS/FCM-ECU is installed properly.
|
|
Check whether the ACC/FCM-ECU is installed correctly (Refer to ).
|
|
Q.
Is the check result normal?
|
|
Go to Step 3
|
|
|
|
Reinstall the ACC/FCM-ECU correctly (Refer to ).
|
|
|
|
STEP 3. Check whether the diagnosis code is reset.
|
|
Q.
Is diagnosis code No.C1753 set?
|
|
Replace the ACC/FCM-ECU (Refer to ).
|
|
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
|
|
|