|
|
1.Remove the ventilation hose from the positive crankcase ventilation valve.
|
|
|
2.Remove the positive crankcase ventilation valve from the cylinder head cover.
|
|
|
3.Install the positive crankcase ventilation valve at the ventilation hose.
|
|
|
4.Start the engine and run at idle.
|
|
5.Place a finger at the opening of the positive crankcase ventilation valve and check that
vacuum of the inlet manifold is felt.
| note |
At this moment, the plunger in the positive crankcase ventilation valve moves back and
forth.
|
6.If vacuum is not felt, clean the positive crankcase ventilation valve or replace it.
7.Apply a small amount of new engine oil to the O-ring on the positive crankcase ventilation
valve, and tighten to the specified torque.
Standard value: 2.5 ± 0.4 N·m
|
)