|
1.Remove the purge control solenoid valve from the inlet manifold, and cover the installation
hole with tape and so on. 2.Connect the hand vacuum pump with the removed purge control solenoid valve. 3.When the engine is cold or hot, apply a vacuum of 53 kPa, and check the condition
of the vacuum.
|
When engine is cold (Engine coolant temperature:
40°C or less)
Engine condition
|
Normal condition
|
At idle
|
Vacuum is maintained.
|
|
|
When engine is hot (Engine coolant temperature:
80°C or higher)
Engine condition
|
Normal condition
|
At idle (after 4 minutes have passed since the engine was started)
|
Vacuum will leak.
|
|
|