|
1.Disconnect the No. 1 exhaust gas temperature sensor connector.
|
|
2.Measure the resistance between terminal No. 1 and No. 2. Standard value: 75 - 190 kΩ (at 20°C) 3.Remove the No. 1 exhaust gas temperature sensor. 4.Measure the resistance while heating the sensor using a hair drier. Normal condition:
|
Temperature (°C)
|
Resistance (kΩ)
|
Higher
|
Smaller
|
|
5.If the value deviates from the standard value or the resistance remains unchanged,
replace the No. 1 exhaust gas temperature sensor. 6.Install the No. 1 exhaust gas temperature sensor and tighten it to the specified torque. Tightening torque: 30 ± 5 N·m
|