Code No. U0121: ASC-ECU Time-out



caution If diagnosis code U0121 is set from AS&G-ECU, surely perform CAN bus line diagnosis.
caution Replace ECU after certainly confirming that the communication circuits are normal.

TROUBLE JUDGMENT


Check Conditions
Judgement Criterion

COMMENTS ON TROUBLE SYMPTOM


Current malfunction
Past malfunction
FAIL-SAFE AND BACKUP FUNCTION

PROBABLE CAUSES




DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnosis



  • Use M.U.T.-III to perform CAN bus line diagnosis.

Q. Is the check result normal?

Go to Step 2.
Repair CAN bus line (Refer to GROUP 54C - Troubleshooting - CAN Bus Diagnostics Table ). After repairing CAN bus line, go to Step 6.

STEP 2. M.U.T.-III diagnosis code



  • Confirm the diagnosis code is set from the ASC-ECU.

Q. Is the diagnosis code set?

Perform troubleshooting of the ASC-ECU (Refer to GROUP 35C - Troubleshooting - Diagnosis Code Chart ).
Go to Step 3.

STEP 3. M.U.T.-III diagnosis code



  • Check that the other ECU performing CAN communication with ASC-ECU sets diagnosis code No. U0121 [Refer to GROUP 54C - CAN Communication-related Diagnosis Code (U-code) Table ].

Q. Is the diagnosis code set?

Go to Step 4.
Go to Step 5.

STEP 4. M.U.T.-III diagnosis code



  • Reconfirmation of diagnosis code.
Confirm again the diagnosis code is set from the AS&G-ECU.

  1. Erase the set diagnosis code.
  2. Ignition switch: "LOCK" (OFF) → ON
  3. Confirm whether the diagnosis code is set.

Q. Is the diagnosis code set?

After replacing the ASC-ECU, go to Step 6.
Intermittent malfunction in CAN bus line between AS&G-ECU and ASC-ECU (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).

STEP 5. M.U.T.-III diagnosis code



  • Reconfirmation of diagnosis code.
Confirm again the diagnosis code is set from the AS&G-ECU.

  1. Erase the set diagnosis code.
  2. Ignition switch: "LOCK" (OFF) → ON
  3. Confirm whether the diagnosis code is set.

Q. Is the diagnosis code set?

After replacing the AS&G-ECU, go to Step 6.
Intermittent malfunction in CAN bus line between AS&G-ECU and ASC-ECU (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).

STEP 6. M.U.T.-III diagnosis code



  • Reconfirmation of diagnosis code.
Confirm again the diagnosis code is set from the AS&G-ECU.

  1. Erase the set diagnosis code.
  2. Ignition switch: "LOCK" (OFF) → ON
  3. Confirm whether the diagnosis code is set.

Q. Is the diagnosis code set?

Go to Step 1.
Check end.