|
1.After setting the concentric slave cylinder to the transmission case, tighten the flange
bolt temporally.
|
|
2.Assemble the concentric slave cylinder adapter with the concentric slave cylinder.
| note |
Fit into the groove of the transmission case.
|
3.Tighten the flange bolt to the specified torque of 10 ± 2 N·m.
|
|
1.Apply specified grease to the clutch disc splines and rub it into the splines with a brush.
Specified grease: MITSUBISHI MOTORS GENUINE Part No. 0101011 or equivalent
2.Use the general service tool to position the clutch disc on the flywheel.
3.Install the clutch cover onto the flywheel.
|
)
)
)
)