REMOVAL AND INSTALLATION



Pre-removal and post-installation operation
  • Engine Room Under Cover Removal and Installation (Refer to GROUP 51 - Under Cover .)
  • Transmission Oil Draining and Refilling (Refer to .)
  • Transfer Oil Draining and Refilling (Refer to .)
  • Heat Protector Removal and Installation <RHD> (Refer to GROUP 32, Crossmember .)
  • Propeller Shaft Removal and Installation (Refer to GROUP 25, Propeller Shaft .)
  • Drive shaft <RH> removal and installation (Refer to GROUP 26-Drive Shaft Assembly .)





Removal steps


1.
Catalytic converter bracket


·
Remove the catalytic converter mounting bolts and move them to the position where they will not interfere with transfer removal. (Refer to GROUP 15 - Exhaust Pipe, Main Muffler and Catalytic Converter )
<<A>>

2.
Transfer assembly


3.
O-ring

REMOVAL SERVICE POINT



<<A>> TRANSFER ASSEMBLY REMOVAL


Move the engine and transmission assembly toward the front of the vehicle to make a gap between the engine/transmission assembly and the crossmember. Pull out the transfer assembly through this gap.