DISASSEMBLY AND REASSEMBLY




< F6MBA >


1.
Transmission magnet


2.
Bearing lock plate


3.
Tapered roller bearing outer race


4.
Oil seal


5.
Cylindrical roller bearing outer race


6.
Oil seal


7.
Tapered roller bearing outer race


8.
Cylindrical roller bearing outer race


9.
Output shaft cover


< W6MBA >


1.
Transmission magnet


2.
Bearing lock plate


3.
Tapered roller bearing outer race


4.
Cylindrical roller bearing outer race


5.
Oil seal


6.
Tapered roller bearing outer race


7.
Cylindrical roller bearing outer race


8.
Output shaft cover

DISASSEMBLY



1.Remove the transmission magnet.

2.Remove the bolt with washer and bearing lock plate.

3.Using special tools, remove the tapered roller bearing outer race.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

4.Remove the oil seal.

5.Using special tools, remove the cylindrical roller bearing outer race.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

6.Remove the oil seal.

7.Using special tools, remove the cylindrical roller bearing outer race.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

8.Using special tools, remove the tapered roller bearing outer race.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

9.Remove the output shaft cover (two pieces).

REASSEMBLY



1.Install the output shaft cover (two pieces) in the transmission case.

2.Using special tool Differential oil seal installer (MB991168), install the tapered roller bearing outer race in the transmission case.

3.Using special tool Differential oil seal installer (MB990699), install the cylindrical roller bearing outer race in the transmission case.

4.Using special tool Input shaft oil seal installer (MB992037), install the oil seal in the transmission case.
Specified grease:
MITSUBISHI MOTORS GENUINE Part No. 0101011 or equivalent

5.Using special tool Bush remover and installer (MB991448), install the cylindrical roller bearing outer race in the transmission case.

6.Using special tool Extension HSG seal installer (MD998550), install the oil seal in the transmission case.
Specified grease:
MITSUBISHI MOTORS GENUINE Part No. 0101011 or equivalent

7.Using special tools, install the tapered roller bearing outer race in the transmission case.

  • Installer bar (MB990938)
  • Bush remover and installer base (MB991445)<F6MBA>
  • Bush remover and installer base (MB991387)<W6MBA>

8.Install the bearing lock plate.
9.Tighten the bolt with washer to the specified torque of 11 ± 4 N·m.

10.Install the transmission magnet in the transmission case.