|
Using special tool Knuckle oil seal installer (MB991015), remove the tapered roller bearing
outer race.
|
|
Using special tools, remove the tapered roller bearing outer race.
- Slide hammer (MB990211)
- Slide hammer puller (MB992039)
|
|
1.Using special tools, press-fit the oil seal until the difference in height between
the transmission case and oil seal is obtained as shown.
- Oil seal installer (MB992210)
- Handle (MB992075)
2.Pack grease to the oil seal lip area. Specified grease: MITSUBISHI MOTORS GENUINE Part No. 0101011 or equivalent
|
|
Using special tool Bearing outer race installer (MB991966), Install the tapered roller
bearing outer race.
|
|
1.Set special tools, Install the tapered roller bearing outer race
- Knuckle oil seal installer (MB991015)
- Installer bar (MB990938)
|
|
2.Press-fit the tapered roller bearing outer race to the height shown in the illustration.
|