)
3.Make sure that the engine starts when the selector lever is in the "N" or "P" range, and does not start when the selector lever is in other range.
4.Start the engine. Release the parking brake.
5.Make sure that the vehicle moves forward when the selector lever is moved to "D" range, or to the "L" range. Also make sure that the vehicle moves backward when the selector lever is moved from the "N" to "R" range.
6.Stop the engine.
7.Turn ON the ignition switch, and move the selector lever from the P to R range. Check that the backup lamp comes on at this time.
| note | Since the vehicle is equipped with the A/T wrong-operation preventive device, the selector
lever cannot be moved out of the "P" position without depressing the brake pedal after turning
"ON" the ignition switch. |