|
1.Disconnect the A/T control solenoid valve assembly connector.
|
|
2.Measure the resistance between the sensor-side connector terminal No. 2 and 3 of the A/T control solenoid valve assembly connector. Standard value:
|
Fluid temperature °C
|
Resistance kΩ
|
10
|
Approx. 6.62
|
25
|
Approx. 3.51
|
80
|
Approx. 0.55
|
110
|
Approx. 0.25
|
|
note |
In the information screen on the multi-information display, the fluid temperature warning comes on when the A/T fluid temperature is approximately 140°C or higher, and automatically goes out when the A/T fluid temperature dropped below approximately 135°C.
|
3.
caution |
The A/T fluid temperature sensor cannot be removed or replaced as a single unit. When the A/T fluid temperature sensor needs to be replaced, replace the valve body assembly.
|
When the resistance of the A/T fluid temperature sensor is outside the standard value, and the fluid temperature warning comes on/goes out at other than the specified temperatures, replace the valve body assembly and the harness.
|