Inspection Procedure 3: The vehicle does not run at the "D" or the "R" range.


PROBABLE CAUSES



DIAGNOSIS PROCEDURE

STEP 1. Check the transmission control cable.
Check the installation status of transmission control cable and inhibitor switch.

Q. Is the check result normal?
Go to Step 2.
Adjust the installation status of transmission control cable and inhibitor switch. .

STEP 2. Check the A/T fluid.
Check the A/T fluid for seizure, fouling, and level.

Q. Is the check result normal?
The procedure is complete.
Go to Step 3.

STEP 3. Remove the transmission assembly from the vehicle.
Disassemble and check the transmission assembly to check if there is a foreign material inside.

Q. Is the check result satisfactory?
Replace the transmission assembly.
Replace the failure part.