Inspection Procedure 17: The starter does not rotate at the "P" or "N" range. (The engine does not start.)


PROBABLE CAUSES



DIAGNOSIS PROCEDURE

STEP 1. Check the engine performance.

Q. Is the check result normal?
Go to Step 2.
Repair the failure, and perform adjustment.

STEP 2. Check the transmission control cable.
Check the installation of the transmission control cable.

Q. Is the check result normal?
Go to Step 3.
Adjust the transmission control cable .

STEP 3. Check and adjust the inhibitor switch.
Refer to .
If the inhibitor switch has a failure, replace it, and then check the trouble symptom again.

Q. Is the check result normal?
The procedure is complete.
Go to Step 4.

STEP 4. Check the electric system.
Check the starter-related wiring for poor insertion of connector or open circuit.

Q. Is the check result normal?
Replace the A/T-ECU.
Repair the failure, and perform adjustment.