After the CVT assembly, engine assembly, and valve body assembly are replaced, their learned value must be initialised. The initialisation procedure is as below.
INITIALISATION PROCEDURE
1.Move the selector lever to the P range and turn the ignition switch to the LOCK (OFF) position. Then, connect M.U.T.-III to the diagnosis connector. 2.Turn the ignition switch to the ON position, and then move the selector lever to the R range. 3.Depress the accelerator pedal while depressing the brake pedal. (Engine is not running.) Using the M.U.T.-III, execute the clear diagnosis code function for the CVT ECU (even if no codes are set).
note
Performing initialisation of the learned value will also erase the diagnosis code.