|
1.
caution |
The A/T fluid temperature should be between
70 - 90°C during the test.
|
Check the A/T fluid level and temperature. Check engine coolant temperature.
- A/T fluid level: "H" mark on the dipstick
- A/T fluid temperature: 70 - 90°C
- Engine coolant temperature: 80 - 100°C
|
|
2.Raise the vehicle so that the wheels are free to turn.
|
|
3.Connect the special tools (3.0 MPa oil pressure gauge [MD998330] and
adapters [MB992127]) to each pressure discharge port. 4.Apply the parking brakes fully. 5.Restart the engine. 6.Check that there are no leaks around the special tool port adapters. 7.At the "D" position, measure the hydraulic pressure during idling (engine speed: 650 ± 50
r/min). Standard value: Approx. 0.385 - 0.525 MPa 8.
caution |
The throttle should not be fully open for more than five seconds.
|
At the "D" position, fully depress the foot brake pedal. Then fully depress the accelerator
pedal while checking the hydraulic pressure indicator, and quickly read the maximum hydraulic
pressure. Standard value: Approx. 1.53 MPa 9.Stop the engine. 10.Remove the O-ring from the port plug and replace it. 11.Remove the special tool, and install the plugs to the hydraulic pressure ports. 12.Start the engine and check that there are no leaks around the plugs.
|