Inspection Procedure 1: CVT-ECU cannot communicate with M.U.T.-III <Vehicles without AS&G system>

SYMPTOMS

CVT-ECU cannot be turned ON.

PROBABLE CAUSES

Damaged wiring harness and connectors
Malfunction of CVT-ECU

DIAGNOSTIC PROCEDURE

STEP 1. Check for short circuit in power supply line between the fusible link No.37 and the CVT control relay connector.

Q. Is the check result normal?

	Go to Step 2.

	Repair the connector(s) or wiring harness.

STEP 2. Check for short circuit in VIG1, VIG2 line between the CVT control relay connector and the CVT-ECU connector.

Q. Is the check result normal?

	Go to Step 3.

	Repair the connector(s) or wiring harness.

STEP 3. Check for open circuit in GND1, GND2 line between the CVT-ECU connector and earth.

Q. Is the check result normal?

	Go to Step 4.

	Repair the connector(s) or wiring harness.

STEP 4. Retest the system.

Recheck the trouble symptom.

Q. Does the malfunction take place again?

	Replace CVT-ECU.

	Intermittent malfunction