DIAGNOSTIC PROCEDURE |
STEP 1. Check for short circuit in power supply line between the fusible link and the DC/DC converter connector |
Q.
Is the check result normal?
|
Go to Step 2. |
|
Repair the connector(s) or wiring harness. |
|
STEP 2. Check for short circuit in VIG1, VIG2 line between the DC/DC converter connector and the CVT-ECU connector. |
Q.
Is the check result normal?
|
Go to Step 3. |
|
Repair the connector(s) or wiring harness. |
|
STEP 3. Check for open circuit in GND1, GND2 line between the CVT-ECU connector and earth. |
Q.
Is the check result normal?
|
Go to Step 4. |
|
Repair the wiring harness. |
|
STEP 4. Symptom recheck after erasing diagnosis code |
Q.
Is the check result normal?
|
Intermittent malfunction |
|
Replace CVT-ECU. |
|