Code No. U1417:
Implausible coding data
Diagnostic function
CVT-ECU checks that the coding information is normal.
JUDGEMENT CRITERIA
The ETACS-ECU coding information about whether the 4WD-ECU is mounted or not is incorrect.
PROBABLE CAUSES
- Malfunction of the CAN bus line
- ETACS-ECU coding information is abnormal
- ETACS-ECU failure or improper assembly
- Malfunction of CVT-ECU
|
|
STEP 1. M.U.T.-III CAN bus diagnostics
|
|
|
Use the M.U.T.-III to diagnose the CAN bus lines.
|
|
|
Q.
Is the check result normal?
|
|
|
 Go to Step 2.
|
|
|
|
|
|
 Repair the CAN bus lines. (Refer to GROUP 54C - Troubleshooting  .)
|
|
|
|
|
|
STEP 2. Use M.U.T.-III to confirm a diagnosis code of other systems.
|
|
|
Check if the ETACS-ECU sets a diagnosis code.
|
|
|
Q.
Is the diagnosis code set?
|
|
|
Diagnose the ETACS-ECU. (Refer to GROUP 54A - Troubleshooting )
|
|
|
|
|
|
Go to Step 3.
|
|
|
|
|
|
STEP 3. ETACS-ECU coding data check
|
|
|
Using M.U.T.-III, check if any abnormality is present in the coding data below which is
stored in the ETACS-ECU.
|
|
|
Final drive
OK <2WD vehicles>: Front Drive
OK <4WD vehicles>: 4WD FF Base
|
|
|
Q.
Is the check result normal?
|
|
|
Go to Step 4.
|
|
|
|
|
|
Repair the coding data. If repair is impossible, replace the ETACS-ECU.
|
|
|
|
|
|
STEP 4. Diagnosis code recheck
|
|
|
Check again if the diagnosis code is set to CVT-ECU.
|
|
|
(1)Erase the diagnosis code.
|
|
|
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
|
(3)Check if the diagnosis code is set.
|
|
|
Q.
Is the diagnosis code set?
|
|
|
Replace the CVT-ECU.
|
|
|
|
|
|
Intermittent malfunction.
|
|
|
|