Steps
|
Item
|
Contents
|
1
|
Learning procedure for engine idling
|
Refer to GROUP 00 "Learning Procedures for Engine Idling ."
|
2
|
Fluid cooling
|
Park the vehicle in a cooler place, stop the engine, and leave the vehicle until the CVT fluid temperature is lowered to the ambient temperature.
|
3
|
Learning in cold engine condition
|
(1) Fluid temperature measurement
|
Use M.U.T.-III to measure the CVT fluid temperature. (Check that the fluid temperature is the same as the ambient temperature.)
|
(2) Line pressure & shift control learning
|
Let the engine idle for 20 seconds in the D range.
|
(3) Direct control learning
|
Run the vehicle at 40 to 50 km/h for 5 seconds in the D range with steady operation.
|
4
|
Learning in hot engine condition
|
(1) Fluid temperature adjustment
|
caution |
When the CVT fluid temperature does not increase to 80°C in cold region, raise the fluid temperature to a maximum extent.
|
Raise the CVT fluid temperature to 80°C.
|
(2) Direct control learning
|
The same procedure as for "Learning in cold engine condition"
|