|
1.Remove the seal rings from the side cover.
|
|
2.
| caution |
Ensure that the special tool spring compressor (MB992196) is correctly
set, directly above the return springs of the spring retainer assembly.
|
While pushing the spring retainer assembly and using the special tool, Spring compressor
(MB992196), remove the snap ring.
|
|
3.
| caution |
Do not remove the return springs from the spring retainer assembly.
|
Remove the spring retainer assembly from the 2-6 brake piston.
|
|
4.
| caution |
Do not feed air abruptly. Otherwise, the 2-6 brake piston may become stuck
in the side cover.
|
Feed air through the oil hole as indicated in the illustration to remove the 2-6 brake
piston from the side cover.
|
|
5.Remove the D-rings from the 2-6 reverse brake piston.
|
|
1.
| caution |
- Never reuse the D-rings.
- Apply ATF to the D-rings before installation.
|
Install D-rings onto the 2-6 brake piston.
|
|
2.
| caution |
Apply ATF to the 2-6 brake piston before installation.
|
Install the 2-6 brake piston onto the side cover.
|
|
3.Install the spring retainer assembly onto the 2-6 brake piston.
|
|
4.
| caution |
Ensure that the special tool spring compressor (MB992196) is correctly
set, directly above the return springs of the spring retainer assembly.
|
While pushing the spring retainer assembly and using the special tool, Spring compressor
(MB992196), install the snap ring.
|
|
5.
| caution |
- Never reuse the seal rings.
- Apply vaseline to the seal rings before installation.
|
Install seal rings onto the side cover.
|
)
)
)
)
)
)
)