DISASSEMBLY AND REASSEMBLY



Disassembly steps
<<A>>
 >>B<<
 1.
 Differential side bearing
<<B>>
 >>A<<
 2.
 Differential side bearing


3.
 Differential sub-assembly


4.
 Adjusting shim

DISASSEMBLY SERVICE POINT

<<A>> DIFFERENTIAL SIDE BEARING REMOVAL

Using the special tool, Side bearing puller (MB990810), remove the inner race of differential side bearing (transmission case side) from the differential sub-assembly.

<<B>> DIFFERENTIAL SIDE BEARING REMOVAL


Using the special tools, remove the inner race of differential side bearing (converter housing side) from the differential sub-assembly.

  • Side bearing puller (MB990810)
  • Oil seal installer (MB991452) <W1CJA>

REASSEMBLY SERVICE POINT

>>A<< DIFFERENTIAL SIDE BEARING INSTALLTION
caution
  • Do not re-use the inner race.
  • Replace the inner race together with the outer race.


Using the special tools, install the inner race of differential side bearing (converter housing side) on the differential sub-assembly.

  • Installer cap (MD998812) <F1CJA>
  • Installer-100 (MD998813) <F1CJA>
  • Installer adapter (MD998823) <F1CJA>
  • Bearing installer (MB992138) <W1CJA>

>>B<< REDUCTION GEAR BEARING INSTALLATION
caution
  • Do not re-use the inner race.
  • Replace the inner race together with the outer race.

Using the special tools, install the inner race of reduction gear bearing (transmission case side) on the reduction gear sub-assembly.

  • Installer cap (MD998812)
  • Installer-100 (MD998813)
  • Installer adapter (MD998823)