|
1.Remove the caliper assembly and the brake disc. Retain the caliper assembly with a
wire and the like to prevent from falling.
|
|
2.Use special tool hub bolt remover (MB991618) to remove the hub bolt.
|
|
3.After fixing the hub using special tool front hub and flange yoke holder (MB990767), install
the plain washer to the new hub bolt and tighten the bolt with a nut. 4.Install the brake disc, caliper assembly and tighten the caliper assembly mounting
bolts to the specified torque. Tightening torque: 58 ± 7 N·m
|