)
| Removal steps |
|||
| 1. |
Propeller shaft assembly (Refer to GROUP 25 - Propeller
Shaft  ). |
||
| 2. |
Cover |
||
| 3. |
Breather hose connection |
||
| 4. |
Connector connection |
||
| 5. |
Bracket |
||
| >>A<< |
6. |
Electronic control coupling |
|
| 7. |
Wave washer |
|
|
INSTALLATION SERVICE POINT |
>>A<< ELECTRONIC CONTROL COUPLING INSTALLATION |
) |
1.Check that the length of the electronic control coupling stud bolt (A) is within the standard
value range. Standard value: 21.6 - 24.4 mm 2.If it exceeds either of the limits, clean the threads for the electronic control coupling and replace the stud bolt. Tightening torque: 13 ± 2 N·m |