DIAGNOSIS PROCEDURE |
STEP 1. M.U.T.-III data list |
Check the following data list (Refer to ). |
|
Q.
Is the check result normal?
|
Go to Step 4. |
|
Go to Step 2. |
|
STEP 2. Check the wiring harness between 4WD switch connector and 4WD-ECU connector terminal sw-1. |
Check the output line for short circuit. |
Q.
Is the check result normal?
|
Go to Step 3. |
|
Repair the defective connector or the wiring harness. |
|
STEP 3. 4WD switch inspection |
Refer to . |
Q.
Is the check result normal?
|
Go to Step 4. |
|
Replace the 4WD switch (Refer to ). Then go
to Step 5. |
|
STEP 4. Check whether the diagnosis code is reset. |
Q.
Is the diagnosis code No.C1613 set?
|
Replace the 4WD-ECU (Refer to ). Then go to
Step 5. |
|
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent
Malfunction ). |
|
STEP 5. Check whether the diagnosis code is reset. |
Q.
Is the diagnosis code No.C1613 set?
|
Return to Step 1. |
|
This diagnosis is complete. |
|