SPECIAL FUNCTION

RESET

Item No.	Display on M.U.T.-III	Initialisation contents
1	SAS adjusted value	Resets the steering wheel sensor neutral position learned value.
3	Centre coupling estimated temp.	Reset the estimated temperature of centre coupling.

TEST

Item No.	Display on M.U.T.-III	Test content	Normal conditions
4	Control OFF	The electronic control coupling (centre) operation stops	Refer to the electronic control coupling (centre) operation check.
6	Centre coupling operation check	Drive the electronic control coupling (centre) with control current of 3 A.	Maximum 60 seconds

1.The test can be performed only when all the following conditions are satisfied.

2.With the test, when any of the conditions below is met, the forced activation will be cancelled.

Any of the wheel speed sensors detects an input of 20 km/h or more (excluding item No. 4 "Control OFF").
A system malfunction is detected.
The forced activation time has elapsed.
M.U.T.-III is removed.
M.U.T.-III clear key is operated.

The sensor neutral position learned value initialisation can be performed only when the vehicle is stopped.