REMOVAL AND INSTALLATION


<4B1, 4N1>


Pre-removal Operation
  • Engine Room Under Cover Front A, B Removal (Refer to GROUP 51 - Under Cover ) <4N1>.

 Post-installation Operation
  • Engine Room Under Cover Front A, B Installation (Refer to GROUP 51 - Under Cover ) <4N1>.




Removal
<<A>>
 >>A<<
 1.
 Engine mounting bracket

<4J1>


Pre-removal Operation
  • Valve lift-ECU Removal (Refer to GROUP 13C - Valve lift-ECU ).

 Post-installation Operation
  • Valve lift-ECU Installation (Refer to GROUP 13C - Valve lift-ECU ).




Removal
<<A>>
 >>A<<
 1.
 Engine mounting bracket

REMOVAL SERVICE POINT

<<A>> ENGINE MOUNTING BRACKET REMOVAL
1.
caution When supporting the engine and transmission assembly with a garage jack, be careful not to deform the engine oil pan.
Place a garage jack against the engine oil pan with a piece of wood in between to support the engine and transmission assembly.
2.Operate a garage jack so that the engine weight is not applied to the engine mounting bracket, and remove the engine mounting bracket.

INSTALLATION SERVICE POINT

>>A<< ENGINE MOUNTING BRACKET INSTALLATION
caution Do not remove small tapping screw.

Tighten the engine mounting bracket mounting bolts by the following procedure.
Order
 Bolt
 Tightening torque
1st
 A
 Approximately 0 - 5.0 N·m
2nd
 B
 50 ± 5 N·m
3rd
 A
 50 ± 5 N·m