REMOVAL AND INSTALLATION


caution
  • The part indicated by * is the nut with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten it to the specified torque.
Pre-removal Operation
  • Front Height Sensor Removal (Refer to GROUP 54A - Height Sensor ). <Vehicles with headlamp automatic levelling system>

 Post-installation Operation
  • Front Height Sensor Installation (Refer to GROUP 54A - Height Sensor ). <Vehicles with headlamp automatic levelling system>
  • Front Wheel Alignment Check and Adjustment (Refer to ).




Removal steps


1.
 Front height sensor and lower arm connecting nut <Vehicles with headlamp automatic levelling system>


2.
 Brake hose bracket
<<A>>
 >>A<<
 3.
 Stabilizer link and strut connection nut


4.
 Knuckle and strut connection


5.
 Strut mounting nut


6.
 Strut assembly

REMOVAL SERVICE POINT

<<A>> STABILIZER LINK AND STRUT CONNECTION NUT REMOVAL

Use a hexagon wrench to remove the stabilizer link and strut connection nut as shown in the figure.

INSTALLATION SERVICE POINT

>>A<< STABILIZER LINK AND STRUT CONNECTION NUT INSTALLATION

Use a hexagon wrench to install the stabilizer link and strut connection nut as shown in the figure.